DIY Simple Wood Bar

DIY Bar

DIY Wood Bar….

This sturdy, simple bar will be a great addition to your man cave.

DIY Simple Wood Bar
Write a review
Print
Ingredients
  1. Materials
  2. 2x4 boards
  3. 4x4 posts
  4. wood glue
  5. nails
  6. paint
  7. fiberboard
  8. Tools
  9. tape measure
  10. framing square
  11. circular saw
  12. drill
  13. hammer
Instructions
  1. Step 1: Construct Side Frames
  2. Each of the two side panels is constructed from two long and two short boards. Use a circular saw to cut four 2" x 4" boards to lengths of 42". Next, cut four 2" x 4" boards to lengths of 15". Place the shorter boards inside the longer ones to form a rectangular frame. Secure the boards with nails.
  3. Step 2: Construct Front Frame
  4. Use a circular saw to cut two 2" x 4" boards to lengths of 42". Next, cut two 2" x 4" boards to lengths of 84". Place the shorter boards inside the longer ones to form a rectangular frame. Secure the boards with nails.
  5. Step 3: Cut Front and Side Panels
  6. Use a table saw to cut two pieces of MDF to fit over the side panels. Next, cut one piece of MDF to fit over the front panel. Apply glue to the edges of the front and side MDF panels and fasten to the frames with nails.
  7. Step 4: Assemble Bar
  8. The side panels connect to the front panel via two 4" x 4" posts. Cut two 4" x 4" posts to lengths of 42". Position one side panel and the front panel at a 45-degree angle with one post at the intersection. Toenail the pieces together to form one bar corner. Repeat with remaining corner.
  9. Step 5: Construct Bartop
  10. Cut a piece of MDF to dimensions slightly larger than the bar to allow for overhang. In this project that would be 21" x 86". Apply glue to the underside of the MDF bartop and fasten to the front and side panels with nails.
  11. Step 6: Complete Project
  12. Paint or stain the wood as desired to give the bar a finished look.
Guru's Man Cave http://gurusmancave.com/

Source:  http://www.diynetwork.com/

DIY Bar 2

Comments

comments